[Shorewall-users] RH 8 and Shorewall Hits\Status Command

Martinez, Mike (MHS-ACS) Mike.Martinez at mhs-helpdesk.com
Fri, 25 Oct 2002 10:31:43 -0500

Thanks Harry!!!

Those commands work a lot better. :-)


-----Original Message-----
From: Harry Venema [mailto:harry@pyrrus.net]
Sent: Friday, October 25, 2002 1:38 AM
To: Martinez, Mike (MHS-ACS)
Cc: shorewall-users@shorewall.net
Subject: Re: [Shorewall-users] RH 8 and Shorewall Hits\Status Command

On Thu, 24 Oct 2002, Martinez, Mike (MHS-ACS) wrote:

> Hi Everyone,
> When I do a Shorewall Hits command it takes about 2-5 minutes to display
> results. 
> Also when I do a Shorewall Status Command it will display all the rules
> really fast but when it gets to where it shows what is connected it again
> sits their for 2-5 minutes.
> RH 7.1 and Shorewall 1.3.9 ran these commands real fast.

It is not a Shorewall problem.
Try the following:

LANG=en_US shorewall hits

In RH8.0 the default language setting (LANG) has been changed to
In RH7.x this setting was en_US.
You can change your system default in /etc/sysconfig/i18n.