[Shorewall-newbies] HELP, FIREWALL & ROUTER with Shorewall on RH9.0

Richard Atcheson ratcheson at earthlink.net
Mon Dec 8 23:52:32 PST 2003

On Tuesday 09 December 2003 05:22 am, -<<- I.R. Harahap -- Medan ->>- wrote:
> ===================================================
> dear all
> i want built Static-Router & Firewall with 3 eth on my Linux  RH9.0  with
> shorewall, so i need help,
Here's how you get started on any Shorewall project.  Simply follow this 
MicroShorewall Howto:

1.  Begin by reading Sections 1, 2, and 3 of the Shorewall Setup Guide
( http://shorewall.net/shorewall_setup_guide.htm#Introduction ) then
2.  Decide what kind of setup you are going to have. i.e, 1 Interface, 2 
Interface and so on.
3.   Draw out or if you like, diagram your setup using as a guide Tom's
drawings in the Setup Guide. Put in your IP numbers, draw arrows so you will 
know how things flow from point to point. Make a picture that you understand.
4.  Once that is done, simply apply the QuickStart Guide for that particular
interface step by step. It should be an easy matter.

If you can't get it to work then read the very simple directions on the 
Getting Help or Answers page of the Shorewall Setup Guide BEFORE calling for 

If you follow these simple steps you will either be able to do the setup for 
yourself, successfully,  or you will have enough information that you can get 
some help quickly here.

Hope this will make life a little easier for all of us.

More information about the Shorewall-newbies mailing list